Tsunami MP-8100 Installation and Management Guide 51
Parameter Description
BSU Name Specifies the System Name given to the BSU (Refer
to Basic Configuration Information). If the BSU
Name is specified, it forces the SU to register to the
BSU with the given Network Name and BSU Name.
If the BSU Name is left blank, it allows the SU to
register to any BSU with the given Network Name.
The first 32 characters of the BSU's System Name
shall be configured here.
Network Name It is the name given to a network so that the BSU
and SU can mutually authenticate. The SU can
register to the BSU only if it has the same Network
Name. The Network Name can be 1 to 32 characters
in length.
WORP MTU WORP MTU (Maximum Transfer Unit) is the largest
size of the data payload in wireless frame that may
be transmitted. The MTU size can range from 350 to
3808 for High Throughput modes.
The default and maximum value of the WORP MTU
is 3808.
Super Framing Super Framing refers to the mechanism that enables
multiple Ethernet/802.3 frames to be packed in a
single WORP data frame. When the WORP MTU size
is configured larger than the Ethernet frame size,
then WORP constructs a super frame with size of
the WORP MTU configured and pack multiple
Ethernet frames. It results in reducing the number of
frames transmitted over wireless medium thereby
conserving wireless medium and increasing the
overall throughput.
Multi Frame Bursting To achieve higher throughput, WORP protocol
allows each side (BSU or SU) to send multiple data
frames in sequence and treats it as a single data
frame. During Multi bursting sequence, the receiver
will not be allowed to interrupt the sequence by
sending any message. By default, this feature is
Enabled.
This parameter is configurable only on BSU and it
turns this feature on (if enabled) or off (if disabled)
for both BSU and SU. When Multi Frame Bursting is
enabled, the number of frames transmitted for each
polling cycle can be configured as part of Quality of
Service (QoS) Configuration.
To Next Page
Loading...