Tsunami MP-8100 Installation and Management Guide 52
Registration Procedure Time-out It specifies the maximum duration for the
registration process to complete once the SU starts
registering with the BSU. Default time is 10 seconds.
Retries This parameter specifies the maximum number of
times a data message is retransmitted, over the
wireless medium, if acknowledgement is not
received. By default, this parameter is set to 3.
Tx Rate This parameter represents the modulation rate at
which the packet will be transmitted from the
wireless device.
NOTE: The supported transmission rates
vary based on the Channel Bandwidth,
Guard Interval, and Number of Data
Streams parameters.
Input/Output Bandwidth Limit This parameter limits the data received on the
wireless interface and transmitted to the wireless
interface. Minimum of 64 Kbps to the maximum
value specified in the License File.
Bandwidth Limit Type This parameter specifies the action performed when
the traffic utilization exceeds the configured
input/output limits.
Policing: When the traffic utilization reaches the
configured limit, the excess traffic will be discarded.
Shaping: When the traffic utilization reaches the
configured limit, the excess traffic will be buffered
and sent at the rate specified in the Output
Bandwidth Limit.
Security Profile Name This parameter represents the security profile
currently used. The default Security Profile Name is
WORP Security. The Security Profile contains the
authentication and encryption methods used to
secure the connection between the BSU and SU.
Refer to Security Configuration.
Radius Profile Name This parameter represents the radius profile
currently used. The radius profile contains the IP
address details of the RADIUS server. Refer to
Configuring the Radius Server Profile (BSU Only).
MAC ACL Status This parameter is used to enable or disable the MAC
Access Control List (ACL). When enabled, the BSU
checks the ACL to allow or deny access to the SU.
This option is available only in BSUmode.
Parameter Description