Proxim Tsunami MP-8100 Series - Page 53

Advanced Configuration
Tsunami MP-8100 Installation and Management Guide 53
NOTE:
• Modifying any of the BSU parameters results in temporary loss of connectivity with the SU.
• MAC ACL Status and Radius MAC ACL Status fields cannot be enabled simultaneously.
4.4.2 Configuring WORP Properties in SU Mode
When the device is in SU mode, only SU-related configuration settings are displayed. Refer to Configuring WORP Properties
in BSU Mode.
Refer to Configuring WORP Properties in BSU Mode for description of rest of the parameters.
To apply the configured properties to the device, click COMMIT.
NOTE:
• Modifying the WORP parameters of either BSU or SU may result in temporary loss of the link.
• When you modify WORP parameters and click COMMIT, it may result in brief interruption of service.
4.4.3 Wireless Interface Properties
In the Wireless Interface Properties screen, you can configure the properties of wireless interface.
To configure the wireless interface properties
1. Click ADVANCED CONFIGURATION > Wireless > Interface 1 > Properties. The Wireless Interface Properties screen
is displayed as shown below.
Radius MAC ACL Status This parameter is used to enable authentication
using RADIUS server. When enabled, the BSU
contacts the RADIUS server for authenticating the
SU during the registration process. This option is
available only in BSU mode.
Parameter Description
Mode System Name given to the BSU (Refer to Basic
Configuration Information). If the BSU Name is
specified, it forces the SU to register to the BSU with
the given Network Name and System Name. If the BSU
Name is left blank, it allows the SU to register to any
BSU with the given Network Name.
Parameter Description