Tsunami MP-8100 Installation and Management Guide 66
To configure the Radius Server profile
1. Click ADVANCED CONFIGURATION > Security > RADIUS. The Radius Server Profile screen is displayed as shown
below.
Figure 4-10 RADIUS Server Profile
2. Enter the appropriate parameters on the Radius Server Profile screen. See the following table that lists the parameters
and their descriptions.
3. Click OK.
Parameter Description
Profile Name Specifies the profile name.
Max Retransmissions Specifies the maximum retransmissions allowed.
Message Response Time Specifies the message response time.
Re Authentication Period Specifies the Re Authentication Period.
Entry status Displays the Radius profile as Enable.
Server Type This is a read only parameter and displays the server type. Two
Server Types are supported: Primary Auth Server and
Secondary Auth Server.
IP Address Enter the Server’s IP address.
Server Port Specifies the port number which is used by the unit and the Radius
server to communicate. By default, RADIUS Authentication
Server communicates on port 1812.
To Next Page
Loading...