Tsunami MP-8100 Installation and Management Guide 81
Adding Protocol ID
a. Click Add to add a new Protocol entry. The following screen appears.
Figure 4-21 QoS PIR Protocol ID
b. Enter the details and click Add. For deleting an entry, click Delete for the corresponding entry in PIR Details
page.
Adding TCP/UDP Source Port Numbers
a. Click Add to add a new entry. The following screen appears.
Figure 4-22 QoS PIR TCP/UDP Source Port Add Entry
b. All the Entries present in the PIR TCP/UDP Port Entries are displayed in the TCP/UDP Port Entry Table. Select the
appropriate radio button and click Add. After adding the entry for this specific PIR, it is displayed in the Existing
TCP/UDP Port Entries table. For deleting an entry, click Delete for the corresponding entry in the PIR Details page.
Adding TCP/UDP Destination Port Numbers
a. Click Add to add a new entry. The following screen appears.
To Next Page
Loading...
