Tsunami MP-8100 Installation and Management Guide 87
4.6.2.3 QoS Class Configuration
1. Click ADVANCED CONFIGURATION > QoS > Class List. Five predefined QoS Classes are displayed in this page.
You can configure maximum 8 entries. QoS Class Name should be unique. This QoS Class can be referred in the
Default QoS Class or L2 Broadcast QoS Class. Any QoS Class referred cannot be deleted.
Figure 4-30 QoS Class Details
Max Messages in Burst Specifies the maximum number of messages that can be sent in a
burst. This value ranges from 1 to 16.
NOTE: Reducing the number of messages impacts the
throughput.
Entry Status Specifies the Service Flow status.
Parameter Description
Default QoS Class This parameter specifies the QoS Class profile that
needs to be associated with an SU which is not listed in
the QoS SU List but connected.
Parameter Description
To Next Page
Loading...
