Tsunami MP-8100 Installation and Management Guide 88
4. Add a New QoS Class:
a. Click Add to add new entry. The following screen appears for configuring the New Class Entry.
Figure 4-31 QoS Class Add Entry
b. Specify the QoS Class Name, Service Flow Name PIR Rule Name Priority and Entry Status and click Add.
L2 Broadcast QoS Class This parameter specifies WORP to use this particular
class for worp broadcast facility.
L2 Broadcast QoS Class is valid only for Downlink
Direction. QoS Class assigned to this profile should
have at least one Downlink SFC.
Parameter Description
Class Name Specifies the Name of the QoS Class. This name length
can range from 1 to 32 characters.
Service Flow Name Specifies the Service Flow to be associated with the
QoS Class. Select one of the possible SFCs that have
been previously configured in the SFC List.
PIR Rule Name Specifies the PIR Rule need to be associated with this
Service Flow. Select one of the possible PIRs that have
been previously configured in the PIR List.
Parameter Description
To Next Page
Loading...
