Tsunami MP-8100 Installation and Management Guide 89
Adding Service Flows in QoS Class
1. Click on the corresponding Details of the QoS Class for adding more Service Flows. Each QoS Class can have
maximum 8 Service Flows. At least there should be one service flow per QoS Class. The following screen is displayed
to configure the new SFC entry inside the QoS Class.
Figure 4-32 QoS Class Service Flow Details
2. Click Add. The following screen appears for association of the new SFC in this QoS Class.
Priority Specifies priority or order of execution of PIRs during
packet identification process. The PIR priority is a
number that can range from 0-63, with priority 63
being executed first, and priority 0 being executed last.
The PIR priority is defined within a QoS class, and can
be different for the same PIR in some other QoS class.
If all PIRs within one QoS class have the same priority,
the order of execution of PIR rules will be defined by
the order of definition of SFCs, and by the order of
definition of PIRs in each SFC, within that QoS class.
Entry Status Specifies the status of the QoS Class as enable/disable.
Parameter Description
To Next Page
Loading...
