Please note:
–Only use perfect sawblades.
– Always remove the mains plug formaintenance and upkeepwork.
–Donot let the device operate unsupervised.
7.2.1 Inside cuts (fig. 8)
Caution!
Always remove the mains plug before releasing the sawblade.
If youmust also make inside cutswhenworking withyour mechan-
ical fret saw, proceedasfollows:
1.Drill ahole in the inside part 1 to be cut out ofyour work piece.
2.Take the sawblade from the topsaw blade guide 2.Proceedasshown
in 6.7.3.1.and in 6.7.3.2, depending on the type ofsaw blade used.
3.Push the sawblade through the drill hole.Reattach sawblade at
the top. Tension the sawblade properly again.
4.Cut out the opening and remove the work piece once the sawblade
has beenremovedagain.
Tip:
If youdrill the hole in such away that it doesnot touch the later
inside contour, youcan allow the sa wline to run tangentially into the
contour.This producesanice evensawing edge.
7.2.2 Grain cuts
For grain cuts, the table is simply tiltedbythe requiredamount.This
works as follows:
1.Slightly loosenknurledscrew 1 (fig. 2) and alignsaw table 2 to the
requiredvalue, using
scale 9 onindicator 8.
2.Tightenknurledscrew 1.
3.Press the work piece particularly firmly against the table foragrain
cut.
8 Service and maintenance
Caution!
Pull the mains plug before making anyadjustments, performing main-
tenance work, orcarrying out repairs!
Note:
The scroll sawisbasically maintenance free.However, to ensure a
long service life youshould clean the device after each use withasoft
cloth, swab, orbrush. Avacuum cleanerisalso advisable for this.
9 Disposal
External cleaning of the housing can be carried out using asoft, pos-
sibly moist cloth. While doing so, amild detergent or othersuitable
cleansing agent can be used. Do not use solvents orcleansing agents
containing alcohol (e.g.benzene, cleaning alcohol, etc.) as these can
corrode the plastic housings.
10 EC Declaration of Conformity
Name and address of the manufacturer:
PROXXONS.A.
6-10, Härebierg
L-6868 Wecker
Product designation: DSH
Article No.: 28092
In sole responsibility, we declare that this product conforms to the
following directivesand normative documents:
EU EMC Directive 2004/108/EC
DIN EN 55014-1 / 02.2012
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 07.2012
EU Machinery Directive 2006/42/EC
DIN EN 61029-1 / 01.2010
Date: 08.04.2013
Dipl.-Ing. Jörg Wagner
PROXXONS.A.
Machine Safety Department
The CE document authorizedagent is identical with the signatory.
- 17 -
To Next Page
Loading...
Need help?
General
