PS Automation PS-AMS PSQ Series User Manual

9
g 5: Netzanschluss
bildung 9: Klemmen derHauptplatine
Wiring to the main board:
Figure 7: Open the cover
Open the cover. Insert the cable into the actuator
via the cable glands.
Figure 8: Main board
The main board provides terminals to
accommodate rigid and flexible cables of wire
widths of 0.14 mm² to 2.5 mm² as well as a PE
screw on the housing.
Caution: Please observe the supply voltage and the
maximum power consumption of the actuator as
indicated on the actuator‘s name plate!
Connect wires as per the enclosed wiring diagram.
Wiring to the terminal box:
Figure 9: Open the terminal box
Open the cover of the terminal box. Insert the
cable through the cable glands to the inside of the
cover.
Figure 10: Plug modules
Unscrew the 4 holding screws of either plug
module from the holding frame inside the cover.
Wiring is made to the back side of the modules.
Each plug module provides 16 numbered terminals
to accommodate rigid and flexible cables of wire
widths of 0.14 mm² to 2.5 mm²
Caution: Please observe the supply voltage and the
maximum power consumption of the actuator as
indicated on the actuator‘s name plate!
Connect wires as per the enclosed wiring diagram.
19
20
21
22
23
18
14
15
16
17
13
12
11
10
9
8
7
1
2
3
5
6
4
plug module

PS Automation PS-AMS PSQ Series Specifications

General

Brand	PS Automation
Model	PS-AMS PSQ Series
Category	Controller
Language	English