PS Engineering
PMA8000BT Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-890-0702 Page 3-10 Rev. 1, Oct. 2010
Music 2 is provided to the passenger positions regardless of intercom mode, when the audio panel is in
Standard Music Distribution, and also in Alternate Music Distribution, but only if the intercom is in the
CREW mode. The pilot and copilot can never hear Music 2, under any condition.
If the passengers always want to hear the source in Music 1, input through the rear connector, regardless
of the intercom mode (ISO/ALL/CRW), select “Music 1 all headsets.”
If the passengers want to hear the music input through the front panel jack, the audio pane MUST be in
Alternate Music Distribution, and the intercom must be in the ALL or ISO mode.
Table 3-3 Music Distribution
3.11.4 Music 1 Volume
In general, we recommend adjusting the entertainment volume at the sources, and only using this as a
master gain control. However, the Music 1 PMA8000BT input can be adjusted from the front panel, if
desired, by pressing the combinations of keys listed.
The Music 1 volume can be adjusted from the front panel, if desired, by pressing the combinations of keys
listed.
Press Hold Function (TEL) and Vol Down (MUTE) (h) for more than one second to decrease music 1 or
MP3 volume. If the buttons are held down continuously, it will decrease the volume three steps per second
Press Hold Function (TEL) and Vol UP (SPR) (i) for more than one second to increase music 1 or MP3
volume. If the buttons are held down continuously, it will increase the volume three steps per second.
Note: Since it is possible to turn the volume completely off, you may need to turn the volume up if you
don’t hear music when you expect to.
It will take about 10 seconds to go from minimum to maximum volume.
3.12 Bluetooth® interface
The PMA8000BT has a Bluetooth interface. The audio panel is always “discoverable,” so you just need to
search for the PMA8000BT from your Bluetooth-equipped phone or music source. The default access code
is 0000, if needed. Once the PMA8000BT has been “paired” with your Bluetooth device, the TEL distri-
bution will act as described in § 3.4.
To Next Page
Loading...
Need help?
General