Product Maintenance
According to the size of the use scene location, there are three robot parking options
available.
1. One-to-one parking: fixed parking locations can be set for each robot.
2. Free mode: multiple parking locations can be set the robots, and the robots can be
parked according to priority.
3. Parking replenishment mode: In addition to the settings of parking locations in 1) and
2), you can also set temporary parking locations in other areas, and when there is location
available, the robot can automatically go to the parking location for replenishment.When
a robot is parking at non-parking location with no task designated, you can choose the
“Return” command to let the robot return to the parking location automatically, or push
the robot to the parking location.
Note: The robot at the temporary location will display "Temporary parking" in the normal
state, when there is location available at food pick-up position, the robot will automatical-
ly to to the pick-up position for parking.
Parking instructions
Temporary stop
Enter into task interface
Keep the disinfection component clean and tidy, for disinfectant spray ports, check and
clean at least once a week. Clean with a clean cotton cloth, when the bottom wheel is
entangled or stuck by debris, the robot needs to be lifted for cleaning.
Disinfection component, drive wheel and auxiliary wheel
Keep the robot body clean with clean cotton cloth. Do not lift, climb, bump, push, or break
the robot or stack things on its body. If it operates abnormally, do not uninstall any screw
or open any cover without permission or instruction of our technical support engineers.
Sensor maintenance
Keep the robot body clean with clean cotton cloth. Do not lift, climb, bump, push, or break
the robot or stack things on its body. If it operates abnormally, do not uninstall any screw
or open any cover without permission or instruction of our technical support engineers.
Robot body maintenance
During the transportation of the robot, it is necessary to meet GB/T 4857.23-2012
requirements for road transport of steel spring vibration-damped trucks, please use
forklifts and other handling tools for transportation. The robot is a valuable equipment,
when you need to manually move the robot, please strictly follow the instructions
below.As shown in the figure, the left and right profiles of the robot (indicated by the
arrows) are the parts that can be stressed, and you can lift the robot through this part.
Please ask two colleagues to lift the profile from both sides, pay attention to balance, and
keep the robot's upright posture during the handling.
Handling of robot
User manual
23 24
To Next Page
Loading...
