Pullman Holt Gloss Boss - After Work Is Terminated

14
AFTER WORK IS TERMINATED
Proceed as follows at the end of the work cycle and before you perform any type of
maintenance:
1.
Turn off the solenoid valve switch (3)
2.
Lift the squeegee
3.
Turn off the aspiration switch (2)
4.
Turn off the brush/main switch (1)
5.
Move the machine to where water is to be drained
6.
Remove the drain plug and empty the tank
7.
Dismantle the brush and clean it with a jet of water (see “DISMANTLING THE
BRUSH” below in order to dismantle the brush)
ATTENTION:
Always wear gloves when doing this
operation to protect yourself from contact with
hazardous solutions
1
2
3