17
SCHEDULED MAINTENANCE
1. CLEANING THE SQUEEGEE TUBE
Check the squeegee tube for clogging if the suction is insufficient or at periodic
intervals. To clean the tube proceed as follows:
1.
remove the tube from the sleeve on the squeegee
2.
Remove the other end from the recovery tank
3.
Wash the inside of the tube with a jet of water, spraying from the end where the
tank is inserted
4.
Reinstall the tube
ATTENTION:
Do not wash the tube that goes from
the suction unit to the suction plug
2. CLEANING THE FILTER AND THE SOLUTION TANK
1.
Unscrew the plug on the suction tank
2.
Remove and clean the filter
3.
Reinstall the filter and the plug
ATTENTION
: Always wear gloves when doing this
operation to protect yourself from contact with
hazardous solutions
ATTENTION
: Disconnect the rapid graft before
removing the reservoir solution (see image page 18).
To Next Page
