8
PREPARING THE MACHINE
1. HOW TO UNPACK THE MACHINE
1. Open the packing on the side indicated
2. Remove the machine from the packing
3. Pull out the recovery tank
2. BATTERY INSTALLATION/CONNECTION
The machine is supplied with battery charger and sealed gel batteries. In case of
using different batteries from those supplied with the machine, use only batteries 12V
6A AGM or Gel and proceed as follows:
The batteries must be housed in the battery compartment located under the solution
tank.
To install the batteries you must:
1. Remove the solution tank
2. Open the two rear hinges that close the battery compartment
3. Rotate the handlebar by lifting the handlebar control lever (see: “FASTENING
THE HANDLEBAR”)
4. Place the battery in the compartment
5. Connect the cables
ATTENTION
: We recommend using exclusively sealed batteries
to avoid acid spillage.
To Next Page
Loading...
