9
PREPARING THE MACHINE
3. CONNECTOR CONNECTON
6. Connect the battery connector to the machine connector
7. Re-assemble everything
ATTENTION
: This procedure must be done by qualified
personnel. Mistaken or imperfect connection of cables to the
connector can cause severe damage to persons and property.
4. RECHARGING THE BATTERIES
Carry out a battery charge cycle before using the machine.
In case of battery's replacing, verify to use proper batteries for the type of battery
charger installed (use only batteries 12V 6A AGM or Gel).
After you switch off the machine, insert the thorn of the battery charger into the plug.
Follow the instructions in the attached booklet in order to properly use the battery
charger.
ATTENTION:
The machine is predisposed with an automatic
system that removes the tension from the electric plant when it's
in phase of recharge the batteries.
ATTENTION:
Avoid totally discharging the batteries: this can
cause damage to them. Recharge within just a few minutes after
the battery discharged signal lamp starts to flash.
ATTENTION:
Never leave the batteries completely discharged,
not even if the machine is not being used.
ATTENTION:
Carefully keep to the instructions provided by the
manufacturer or its retailer when performing daily battery
recharge. All installation and maintenance procedures must be
done by expert personnel. Danger of gas fumes and leakage of
corrosive fluids. Danger of fire: do not approach with open
flames.
5. BATTERY CHARGE LEVEL GAUGE
The battery charge level gauge is a digital unit with 4 fixed and one flashing position.
The numbers on the display give an approximate idea of the level of charge.
4
= maximum charge,
3
= charge 3/4,
2
= charge 2/4,
1
= charge 1/4,
0
= batteries
discharged (flashing)
ATTENTION
: The brush motor automatically turns off a few
seconds after the flashing “0” appears. The remaining charge
permits to finish drying before carrying our recharge.
To Next Page
Loading...
