12
WARNING:
1. Once you have the trailer located and are ready to unhitch, block the trailer wheels so it will not roll back or forward.
2. Pull the Latch Handle towards the rear of the vehicle and rotate either clockwise or counterclockwise into the
adapter ball from the tube.
3. Extend the trailer jacks until the ball is fully removed from the Coupler Tube and above the top of the coupler
funnel.
4. After lowering the truck’s tailgate, disconnect the trailer’s electrical cord and break-away switch cable, then pull
forward.
is latched before moving the trailer.
UNHITCHING
CHALLENGE VS. SOLUTION
CHALLENGE SOLUTION
Cannot open the Latch Pin. Should only be restricted if trailer is applying pressure to the pin.
Raise trailer jacks to relieve ball pressure against pin.
pin.
(particularly near the junction of the king pin and skid plate),
bent, skewed, or king pins that are too long or too short can
(800) 443-2307 and we will give you suggestions what you can do
to correct these problems.
Trailer overhang is hitting the truck bed rails when
the trailer and truck are at sharp angles.
Raise or lower the hitch coupler height and/or lower the king pin
and bottom of the trailer.
operate.
Spray the locking mechanism with WD-40. Work the handle until
it slides freely. If the problem persists, you may need to degrease
and re-lube all working parts.
I need to have a professional evaluate my
SuperLite 2600.
Contact PullRite’s Customer Service Dept. at (800) 443-2307.
Your needs will be assessed and resolved by PullRite or you will
To Next Page
Loading...
