PULOON Technology Inc.
LCDM-1000
30
- Are the banknotes normally loaded in the CASH CASSETTE ?
- Are the DIP SWITCHES properly set to your banknotes?
- Check the reject code referred to the below Table 7-1.
( To catch the reject code on TEST PROGRAM, you should
set the dip switch #3 to OFF like the Table 7-2. )
Check
Point
Over RejectMeaning
- Please do the proper service action for each case referred to
the Table 7-X.
Action
< Table 7-1 : Reject Code>
44HCODE
TABLE 7
The banknote are not normally passing on the check sensor
because of fast consequential pickup.
9C 03
9C 00
9C 9D
9C 9E
9C 9F
9C 80
3E
35
3D
3C
38
36
3F
33
Reject
Code
The banknote passed on check sensors is considered as too
much skewed.
The length measured on check sensors is not out of limit.
Either check sensor could not detect the banknote.
The banknote length is so short that it may be the damaged
or folded banknote.
The banknote length is so long that it may be the overlapped
banknotes.
The thickness of banknote is abnormally thin.
The banknotes suspected as double are detected.
The banknote is skewed too much on the diverter sensor.
One more banknote is picked up during the processing the
dispense command.
One more banknote is picked and followed in the final
pickup trial.
The distance between banknotes is too close.
Suspected Cause
To Next Page
Loading...
Need help?
General
