PULOON Technology Inc.
LCDM-1000
33
< Table 7-4 Abnormal Clutch or Pick-up Roller (Code: 9C 03, 9C 00) >
It may be caused by the out-of-quality clutch, which is sticking to the power
transmission all the time. So the clutch should be replaced with new one.
Otherwise, the abnormal pick-up roller may cause the over-reject. It needs
replacement with new one, in order to fix the problem.
< Table 7-5 Skew, Obstacle on Path (Code: 9C 80, 9C 9D, 9C 9E, 9F) >
In case of piece cut from the bad banknote or improper material on the path,
it enables to cause the skew amplification, which can occur over-reject.
The note be changed with new one or the path should be cleared by dispensing
the thick note size paper.
Over RejectMeaning
44HCODE
TABLE 7
To Next Page
Loading...
