LCDM-2000
- Is CHK SENSOR 1& 2 & 3 & 4normal?
- Is the assembling condition of GUIDE CASH FEED 1& GUIDE
CASH FEED 3 ASS’Y normal ?
- Is idle roller rotation in the GUIDE CASH FEED 2 ASS’Y
normal?
- Is fixing screw in GUIDE CASH FEED 1 / 2 / 3 ASS’Y normal?
Check Point
Jam in the CHK SENSOR 1 / 2 or 3 / 4 partDetail
- Try again after checking above situation.
- In case of Jam, Turn a handle shown below
Management
33 , 4CCODE
To Next Page
Loading...