Pulsar Accolade XP50 Operating Instructions

= Confirm your selection with a brief press of the M
button.
= Press and hold down the М (3) button to enter the
main menu.
= Select the desired palette with the UP (2)/DOWN
(5) buttons.
Calibration
Wi-Fi
settings
This menu option allows you to set up your device
for operation in a Wi-Fi network.
Wi-Fi setup
This menu option allows you to set a password to
access your thermal imager from an external
device.
The password is used to connect an external device
(i.e. smartphone) to your thermal imager.
= Press and hold down the М (3) button to enter the
main menu.
= Select the menu option with the UP (2)/DOWN (5)
buttons.
= Press briefly the M button to enter submenu
«PAS».
= The default password (12345 or 12345678
depends on product firmware) will appear on the
screen.
= Set the desired password with the UP (2)/ DOWN
(5) buttons (button UP to increase value; button
DOWN to reduce). Switch between digits with a
short press of the M button.
= Save the password and exit the submenu with a
long press of the M button.
Password
setup
Access
level setup
Owner
Guest
Access level setup
This menu option allows you to set required access
level of the Stream Vision application to your
device.
= Access level Owner. The Stream Vision user has
the complete access to all device's functions.
= Access level Guest. The Stream Vision user has
the access only to the real time video stream from
the device.
Settings
The following settings are available:
English
= Select one of the available interface languages
with a short press of the UP/ DOWN buttons:
English, French, German, Spanish.
= Select option «Settings» with the UP (2)/DOWN
(5) buttons. Press briefly М to confirm.
= Press briefly М to confirm.
Selecting interface language
= Press and hold down the М (3) button to enter the
main menu.
= «Language« with UP/DOWN.Select option
= Switch between languages with a short press of
the M button.
= Save selection and exit the submenu with a long
press of the M button.
Language
Date
= Select option «Settings» with the UP (2)/DOWN
(5) buttons. Press briefly М to confirm.
= Select option «Date« with UP/DOWN.
= Press and hold down the М (3) button to enter the
main menu.
= Press briefly М to confirm.
Date setup
Black Hot palette (white colour corresponds to
low temperature, black colour – to high
temperature)
Red Hot
Red Monochrome
Rainbow
Ultramarine
Violet
Sepia
Note: A long press of the UP button (2) also
activates the change of a color palette.
Selecting calibration mode
There are three calibration modes: manual (M),
semi-automatic (SA) and automatic (А).
= Select the desired calibration mode with the UP
(2)/DOWN (5) buttons.
= M or e d et ail s i n t he s e ct ion « Sen so r
calibration».
= Confirm your selection with a brief press of the M
button.
= Press and hold down the М (3) button to enter the
main menu.
14
13

Pulsar Accolade XP50 Specifications

General

Objective Lens Diameter	50 mm
Display Type	AMOLED
Pixel Pitch	17 µm
Frame Rate	50 Hz
Video/Photo Recording	Yes
Built-in Memory	16 GB
Wi-Fi	Yes
Eye Relief	15 mm
Fogproof	Yes
Operating Time	Up to 8 hours
Power Supply	3V
Battery Life	8 hours
Operating Temperature	+50°C
Battery Type	B-Pack (changeable battery packs)
Weight	900 g