Pulsar W880 - TEMPERATURE CALIBRATION; How to Calibrate Temperature

38
English
39
English
ALARM ENGAGEMENT/DISENGAGEMENT
Press to select the desired alarm channel.
E
With each press, the selected alarm is engaged and disengaged
alternately.
D
At the designated time, the TIME alarm sounds for 35 seconds with two 10-second
intervals. The ALTIMETER alarm and H2O alarm sound for 5 seconds. To stop the
alarm while it is sounding, press any button.
Alarm mark
Keep holding down for 4 seconds to disengage all the alarm at one
time.
E
E
C
D
B
A
D
E
C
D
B
A
E
C
D
B
A
E
C
D
B
A
E
s
s
BATTERY CHANGE
Battery life : Approx. 2 years
Battery : CR2032
l
The battery life may be less than 2 years if the alarm is used more than once a day
and/or the illuminating light more than 3 times a day when eco mode is activated for
12 hours a day.
l
As the battery is inserted at the factory to check the function and performance of
the watch, its actual life once in your possession may be less than the specified pe-
riod.
l
When the battery expires, be sure to replace it as soon as possible to prevent mal
-
function.
l
We recommend that you contact an AUTHORIZED PULSAR DEALER for battery
replacement.
l
Battery life indicator
When the battery voltage becomes low, the battery mark starts ashing. In such a
case, have the battery replaced with a new one as soon as possible.
l
Necessary procedure after battery change
After the battery is replaced with a new one or if an abnormal display (broken digits,
etc.) appears, follow the procedure below to reset the IC.
2
Years