www.PyleUSA.com 7
RECHARGING BATTERY
1. Before charging, make sure the battery is correctly installed.
2. The procedure of charging the product is as follows: rstly, connect the
adapter output into the DC jack, and then plug into power socket of the
other end, a blue light will ash.
3. After fully charged, the indicator light will turn to solid blue light.
4. When the product runs out of power, LED indicator will turn red/purple
which prompts the user to charge the product.
5. To ensure the best performance and lift span of the battery, please charge
the product for at least 3 hours continuously. After fully charged for 3 hrs,
indicator light will turn to solid blue light. The product can do cleaning
after 3 hours charging.
NOTE:
a. Make sure the robot will fully charge not less than 8 hours for the rst time.
b. When the battery is low, please charge as soon as possible:
c. If you are not using the robot for an extended period of time, please fully
charge the battery and remove it, put it in a well ventilated and dry place.
d. If the robot will not be used for more than 3 months, please charge the
robot using the adaptor for 8 hours.
Adapter Plug
Adapter Plug Outlet
To Next Page
Loading...
