To Next Page
R
Randall BryantJul 29, 2025
What to do if my Pure Clean PUCRC95 Vacuum Cleaner LED indicator flashes red quickly?
- ZZachary EscobarJul 29, 2025
The battery of your Pure Clean Vacuum Cleaner likely has low power. Fully charge the battery.
What to do if my Pure Clean PUCRC95 Vacuum Cleaner LED indicator flashes red quickly?
The battery of your Pure Clean Vacuum Cleaner likely has low power. Fully charge the battery.
Why does my Pure Clean PUCRC95 suddenly stop cleaning and the indicator stays blue?
This usually happens because the Pure Clean Vacuum Cleaner was picked up, and its sensors detect a cliff or a wheel is off the ground. Put the robot on a solid floor and restart it.
What to do if my Pure Clean PUCRC95 Vacuum Cleaner does not change direction when it hits an obstacle?
This may be due to a bumper sensor fault. Check the sensor to see if it is covered by any object.
What to do if the blue LED flashes once and the red LED flashes once on my Pure Clean PUCRC95 Vacuum Cleaner?
The side brush of your Pure Clean Vacuum Cleaner might be stuck. Put the robot on a flat surface and clean the side brush.
General| Type | Robot Vacuum Cleaner |
|---|---|
| Model | PUCRC95 |
| Filter Type | HEPA Filter |
| Charging Time | 4 hours |
| Voltage | 14.4V |
| Battery Life | 90 minutes |
| Dustbin Capacity | 0.6 liters |
| Frequency | 50/60 Hz |
| Dust Capacity | 0.6 liters |
| Cord Length | Cordless |
Highlights the product's strong suction power for thorough cleaning of even tiny dust.
Lists all included accessories and the main body of the robot vacuum.
Provides a labeled diagram of the robot vacuum's main body parts.
Describes the charging station, its signals, and power socket.
Details the features and buttons of the remote controller for operating the robot.
Step-by-step guide for charging the robot, including station placement.
Instructions on starting up, standby, sleep mode, and powering off the robot.
Guide on emptying, washing, and reinstalling the dust bin and filters.
Addresses issues where the robot stops cleaning and the indicator stays blue.
