www.PyleUSA.com
13
PRODUCT MAINTENANCE
1. Cleaning Side Brushes
Clean the side brush when it gets dirty and replace it if it's damaged.
Maximum life span for side brush is 12 months.
Note: Before replacing side brushes, please pay attention to the left mark
and the right mark (‘L’/ ‘R’) on side brushes, which match with the ‘L’/ ‘R’ mark
on the bottom base of robot.
2. Cleaning Dust Bin and Filters
Empty and clean dust bin after each use following the steps as shown in the
below gures:
Note:
a. Wash primary lter after 15~30 days of use.
b. Re-install the HEPA and primary lter after they’re fully dry.
c. HEPA and primary lter could be replaced when needed.
d. Do not bake the lters under intense sunshine.
Press
A. Press PUSH to open the cover.
B. Take out dust bin
C. Take out HEPA.
D. Open dust bin cover,
take out primary filter.
E. Empty dust bin.
F. Wash dust bin and
primary filter under
tap water.
G. Clean HEPA filter
with brush, avoid
washing it under water.
H. Install primary filter and HEPA back into
the dust bin.
To Next Page
Loading...
