Pure Clean PUCRC90 - Product Maintenance; Cleaning Side Brushes; Cleaning Dust Bin and Filters; Cleaning Sensors and Charging Pins

1. Cleaning Side Brushes
Clean the side brushes when it gets dirty and replace if it’s damaged.
NOTE:
Before replacing side brushes, check and match "L” “R” mark on both side brush
and bottom of robot.
2. Cleaning dust bin and lter
Clean and empty dust bin after each use, steps are as shown in below figures.
NOTE:
After taking out dust bin, check whether there is foreign matter stuck in suck
passage and clean it. Wash HEPA filter after 15-30 days’ use. And replace it after
use for 6 months at maximum.
• Install both HEPA and primary filters when they are dry.
• HEPA and primary filter could be replaced if needed.
3. Cleaning cli sensors and auto charging pins.
Slightly clean the sensor window and auto charging
pins with a soft dry cloth
NOTE:
Charge connecting points on charging home
base if it needs cleaning.
J 7 * .
U P `
www.PyleUSA.com
10