EasyManuals Logo

Pure Humidifier ES Series Installation Instructions

Default Icon
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
TM
PLEASE READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY. PROPER OPERATION AND HUMIDITY CONTROL
IS POSSIBLE ONLY WITH PROPER INSTALLATION AND MAINTENANCE.
To ensure proper installation of this product, it must be installed by quali ed HVAC and electrical contractors, and must be
in compliance with local, state, federal, and governing codes. If installed improperly this product may cause damage to
property, severe personal injury, or death as a result of electric shock, burns, and/or re.
WARNINGS
SERVICING
Disconnect main power before servicing or maintaining humidi er.
The humidi er system including the humidi er tank, steam supply piping, condensate piping and steam distribution grid can
be extremely hot and can cause burns if touched.
Do not use hydrochloric acid descalers or bleach to clean the tank. Consult the factory if you are unsure about which
chemical descaler to use.
ELECTRICAL
Electrical work should be done by quali ed electrical contractors and must be in compliance with local, state, federal, and
governing codes.
PLUMBING
Plumbing and pressurized steam work should be done by quali ed installers and must be in compliance with local, state,
federal, and governing codes.
Drain and over ow water can be 212°F (100°C). If you are not using a DCT-927 Drain Tempering Kit, allow the water to cool
before draining tank.
INSTALLATION
This humidi er produces steam at atmospheric pressure. Do not install any components between humidi er tank and steam
distribution grid which can block or restrict steam ow.
Do not mount on hot surfaces.
Do not mount on vibrating surfaces.
High chloride content in feed water can cause chloride stress cracking and chloride pitting in stainless components. Chloride
stress corrosion cracking (CSCC) and chloride pitting of stainless steel components is not covered by warranty.
Use of mineralized (hard or soft) tap water will cause ll valve failure and void the warranty. PURE Humidi er Co.’s ES
Series should be installed on applications that require tap water.
Do not adjust any components inside humidi er control box without consulting the factory.
For indoor use only unless supplied with an Outdoor Enclosure.
WARNINGS
1

Other manuals for Pure Humidifier ES Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pure Humidifier ES Series and is the answer not in the manual?

Pure Humidifier ES Series Specifications

General IconGeneral
BrandPure Humidifier
ModelES Series
CategoryHumidifier
LanguageEnglish

Related product manuals