PURE FREE STEP - Page 7

Pure Free E-Bike
2
(A)
(B)
7.
(1)
(2)
6.5.
To adjust the angle of the handlebar stem, rst
fully loosen the bolt on the underside of the
stem (1). Then, loosen the bolts on the side of
the stem (2). Move the bars to the angle you
want, then tighten bolt (1) carefully to lock the
position. Aer this, tighten bolts (2) rmly (up to
10-15Nm if you have a torque wrench).
Check that the stem is secure by placing the
front wheel between your legs and twisting the
handlebars. If the bars and wheel move out of
the 90° alignment, you will need to realign and
tighten the stem bolts further.
Double check that the handlebars are still
90°to the front wheel, then tighten the stem
bolt (A) to secure it into position. If you have a
torque wrench, tighten to 15-20Nm (NOTE: the
bolts securing the handlebar (B) should only
be tightened to 5-6Nm). If you don’t, aim to
rmly tighten by hand without straining to your
full strength.
8.
Using your ngers, begin to t the pedals to
the matching colour-coded cranks, turning the
le pedal anti-clockwise, and the right pedal
clockwise to t. Once the pedals are loosely
installed, tighten with the supplied 15mm spanner
- be careful not to damage the threads by forcing
the pedal in. Pedals should be tightened very
rmly (30-40Nm if you have a torque wrench).