CAREFULLY READ ALL
INSTRUCTIONS THOROUGHLY
BEFORE OPERATING
9
• Do not push produce into the feed tube with your fingers or other utensils.
•
Always use the pusher provided. Do not place hand or fingers into
the food tube when it is attached to the juicer. If food becomes lodged
in the feed tube, use the pusher to dislodge it. Turn the motor o and
ensure that all moving parts have stopped before disassembling the juicer
to remove the remaining food.
• If the cutter jams and the motor stalls, immediately turn the machine
o and then clear the blockage. Leaving the motor on for more than 10
seconds when stalled may cause permanent motor damage.
• Never operate the motor with the press plate removed. Severe damage
will occur if the piston reaches full extension without the press plate
installed.
• Make sure the juice tray is properly centered on the press plate prior to
operating the press.
• The PURE Juicer is equipped with an IEC plug/receptacle on the back of
the machine. The PURE Juicer is designed to operate on 115 volts or 230
volts at 50hz or 60hz. All juicers shipped from PURE Juicer Company are
set to 115V unless otherwise marked. For ease of use PURE chose the IEC
plug/receptacle to simplify connecting the machine to the wall receptacle.
This is the same style of cord found on most computers. PURE recommends
a dedicated 15 amp receptacle and circuit to power your juicer.
• For countries/areas/territories with 230 volt electrical supply, connecting
the PURE Juicer to the local voltage is as simple as finding a
replacement power cord that fits local outlets and has an IEC connector
on the end. Use a cord no longer than 2 meters. Confirm there is a 230
volt label attached next to the IEC plug/receptacle. If not, proceed to the
instructions on page 60 to configure the motor to 230 volts.
• Make sure the motor is configured to 230V before operating or irreparable
motor damage will occur. If in doubt contact an electrician.
• Do not modify the plug in any way. The unit has a 3-pin polarized plug.
To reduce the risk of electric shock, this plug will fit in a polarized outlet
only one way. If the plug requires replacement and you are unsure how
to change the plug, contact a qualified electrician.
To Next Page
Loading...