10
Active and Standby operation
You can adjust the brightness level and the duration that the screen is illuminated when switched
on or in standby. Select Active operation to adjust the display settings that apply when the radio
is switched on or Standby operation to adjust the display settings that apply when your radio is
in standby.
Brightness By default, the display brightness is set to ‘Automatic’ in active and standby
modes, which means that the brightness adjusts to suit the lighting level
around your radio. If you want to change this setting, Tap Manual and use
the Select dial to adjust the brightness from 1 (low) to 10 (high). Push to
confirm, or tap OK. You can switch back to automatic brightness by tapping
Automatic.
Screen duration
The length of time the screen is illuminated after a dial is turned, the screen
is tapped or a button is pushed. Choose between Always on (default) or Off
after 7 seconds.
To Next Page
Loading...
