PURE TEMPUS-1 User Manual

6
Quick start
This section provides information on how to set up and start using your TEMPUS-1.
1
Fully extend the telescopic aerial, connect the mains adapter and plug in to your power supply.
2
Set the volume control to low and push the Standby button to switch the unit on. The LCD lights up and the
display shows ‘PURE TEMPUS-1’ and a progress bar on the bottom line indicates the progress of an autotune
to find the stations available in your area. The stations found will be stored in alphanumeric order and the first
station on the list will be selected.
3
Adjust the volume control if required.
4
Turn the Tune knob to see all the stations available. Push to select and listen to another station.
5
Push the Info button and repeat to cycle through the optional display modes including the full screen clock.

PURE TEMPUS-1 Specifications

General

Type	DAB/FM Radio
Display	LCD
Alarm	Yes
Speaker	Built-in
DAB Support	Yes
FM Support	Yes
Presets	20
Sleep Timer	Yes
Headphone Jack	Yes
Power Supply	Mains
Frequency Range	FM 87.5-108 MHz