PYE PPAC15 - Trouble Shooting; Problem Resolution Guide

12
TROUBLE SHOOTING
Before contacting the retailer for replacement, check the below first to see if it can solve the problem:
Problem Cause Solution
The air
conditioner does
not function.
No power supply.
Connect to a functioning power outlet
and switch on.
Is the LCD flashing FL?
Drain the water.
Timer function is active.
Deactivate Timer function.
The air
conditioner does
not seem to
perform.
In direct sunlight.
Close curtains.
Windows or doors are
open, many
people, or a heat source in the room.
Close doors and windows, and remove
the heat source.
Dirty filter.
Clean or replace the filter(s).
Air inlet or air outlet blocked. Remove the blockage.
Room temperature lower than the
selected value.
Change temperature selection.
The unit is noisy. Unit stands uneven.
Place on an even, solid surface (less
vibrations).
The compressor
does not work.
The overheat protection is probably
activated.
Wait 3 minutes until the temperature has
decreased, then turn on the unit again.
The remote
control does not
function.
Distance is too great.
Make sure the remote control is correctly
aimed at the control panel.
Remote control signal not detected by
the control panel.
The batteries are drained.
Replace the batteries.
Cautions: Switch off the unit and unplug it immediately if anything abnormal happens. Then contact a
qualified electrician.
SPECIFICATIONS
Model:
PPAC15
Permissible excessive operating pressure
(Suction/Discharge): 1.0MPa/3.5MPa
Cooling capacity: 4.4kW
Maximux allowable pressure (Low pressure
side/High pressure side): 1.5MPa/5.5MPa
Refrigerant/Charge: R410a/615g
Air Flow: 520m3/h
Power Supply: 220-240V/50Hz
Noise: 56dB(A)
Rated input (cooling): 1750W
Net weight: 35kg
Dimensions (WxHxD): 500x840x390mm
Gross weight: 40kg
GAF Control (Sale) Pty Ltd
441 Kororoit Creek Road (Po Box 19)
Altona Vic 3018
Tel: 1300 659 489