12. RDM (random), preset station 4 button, keypad 4
13. -10 (previous 10 tracks), preset station 5 button, keypad 5
14. +10 (next 10 tracks), preset station 6 button, keypad 6
15. ST (stereo) button, keypad 7
16. LOUD (loudness) button, keypad 8
17. AMS (automatic music search) button, keypad 9
18. MODE button, keypad
19. EQ (Equalizer) button, keypad
0
20. LOC (local)/DX button, keypad #
Remove Insulating Sheet
The remote control comes with an insulating sheet
attached to the underside of the remote control, as
illustrated on the right. The remote control will not
work until the insulating sheet is removed.
Replace Lithium Battery Cell
1. When the lithium cell battery becomes weak,
replace it as illustrated on the right.
2. Press and hold the movable block in the direction
indicated by arrow 1. At the same time, pull the cell
holder out of the remote control in the direction
indicated by arrow 2.
3. Replace the old cell with a new one, making sure
the (+) polarity is facing upward.
4. Re-insert the cell holder into the remote control
Remote Control Operation
Position the emitting window of the remote control toward the sensor window
of the unit.
•
The operation angle for front panel remote control reception is about 30
degrees.
•
The distance between the emitting window of the remote control and
the sensor window of the unit should remain less 5 meters.
•
Cell leakage may cause damage to the remote control.
•
Do not throw cells into as this may cause an explosion.
•
Keep battery cells out of reach of children.
14
To Next Page
Loading...
Need help?
General
