FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following tw
o conditions: (1) this device may not cause harmful interference, and (2) this device must a
ccept any interference received,including interference that may
cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for
Compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B d
igital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide re
asonable protection against harmful interference in a residential installation. This equipmen
t generates uses and can radiate radio frequency energy and, if not installed and used in a
ccordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
‐
Reorient or relocate the receiving antenna.
‐
Increase the separation between the equipment and receiver.
‐
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
‐
Consult the dealer or an experienced radio/TV technician for help important announcem
ent .
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is applicable to only
mobile configurations. The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
To Previous Page
Loading...
Need help?
General
