Pyle PPBCM9 - Photo; Audio Only; Infrared Mode

⑧ Frequency setting: Press the “Confirm” button to enter options list, press
‘Up’/’Down’ to choose the “50”/“60HZ”, then press the “Confirm” button to
confirm it.
⑨ Battery saving mode: Press the “Confirm” button to enter options list, press
‘Up’/’Down’ to choose the “on”/”off”, then press the “Confirm” button to
confirm it.
⑩ Date and time: Press the “Confirm” button to enter options list, press
‘Up’/’Down’ to choose the Date and Time then press the “Confirm” button to
confirm it. Press “Audio” button to choose which part of the time you want to
change.
⑪ Reset All: Press the “Confirm” button to enter options list, press ‘Up’/’Down’ to
choose the “on”/”off”, then press the “Confirm” button to confirm it.
After finishing settings, press “OK” to return the recording standby state.
4. Video
In the power on standby mode, press “Video” button to start recording, there
will be recording time at the upper right corner. Press the “Video” button again
to stop recording, the videos will be saved in the SD card automatically, and display
will return to standby state.