Pyle PSLSW4 - Preparations; PSLSW4 Front and Back Panels

www.PyleUSA.com
2
PSLSW4 - PSLSW6 lets you connect up to four (PSLSW4) or six ( PSLSW6) separate
pairs of speakers to your stereo receiver/amplier. The control center is especially
convenient if you have speaker sets in dierent rooms and want to turn them on
and o independently. You can enjoy the convenience and exibility of listening
to multiple speaker pairs simultaneously.
The control center lets you use one to four (PSLSW4) or six (PSLSW6) sets of
speakers at a time, and is designed to operate with a stereo receiver/amplier
that has a maximum of 100 watts per channel, and with speaker systems that
have a minimum impedance of 8 ohms (see “Impedance Chart” on page 6)
PREPARATIONS
• Use the PYLE Speaker Selectors only with ampliers rated at 100 watts per
channel or less.
• Your PYLE Speaker Selector is designed to accept any size cable up to 14 gauge
non-terminated speaker wire. If you're using non-terminated speaker wire, do
not use any speaker wire that is larger than 14 gauge. The lower the gauge
number, the larger the cable (e. g: 12 gauge is larger in actual physical size
than 14 gauge).
• Do not hook the outputs of one selector into the inputs of another speaker
selector together.
• Before you connect the AC power source, make sure you set ALL speakers ON/
OFF to OFF.
• Left and right "commons" are isolated to work with all types of ampliers.
• Auto transformer impedance protection.
PSLSW4 Front and Back Panels