How to fix a Pyle Receiver when the radio doesn't work?
If the radio on your Pyle Receiver isn't working, start by checking the antenna cable and ensure it's firmly inserted. If the signals are too weak, try selecting a station manually.
Why is there no sound coming from my Pyle Receiver?
If there is no sound from your Pyle Receiver, there might be a couple of reasons. First, check if the volume is set to the minimum level and adjust it to a desired level. Second, the wiring might not be properly connected. Ensure that all wiring connections are secure.
What to do if my Pyle PLR31MP Receiver has no power?
If your Pyle Receiver has no power, there are a couple of things to check. If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. Also, the fuse might be blown, in that case, replace the fuse.
What to do if the operation keys on my Pyle PLR31MP do not work?
If the operation keys on your Pyle Receiver aren't working, it could be due to a built-in microcomputer malfunction caused by noise. Try pressing the RESET button. Also check if the control panel is properly fixed into its place.
Details the process for installing the unit using the front-mount method.
Explains how to install the unit using the rear-mount method for specific vehicles.
Important safety and care instructions for handling the detachable control panel.
Identifies and describes the purpose of each button on the unit and remote.
How to connect a USB driver and play MP3/WMA files.
How to insert and play MP3/WMA files from a memory card.
Detailed explanation of each button on the remote control.
General| Bluetooth | Yes |
|---|---|
| USB Port | Yes |
| SD Card Slot | Yes |
| AM/FM Radio | Yes |
| FREQUENCY RESPONSE | 20Hz - 20kHz |
| INPUT SENSITIVITY | 200 mV |
| Channels | 2 |
| TONE CONTROL | Bass, Treble |
| LOAD IMPEDANCE | 4-8 Ohm |
| Input Impedance | 10k Ohms |
| Output Impedance | 4-8 Ohm |
| S/N RATIO | 80 dB |
| Signal-to-Noise Ratio | 80 dB |
To Next Page
