Pyle PLR31MP User Manual

5
OPERATION
LOCATION OF KEYS
SWITCHING ON/OFF THE UNIT
Press
/MUT button to turn on the unit. When
the system is on, press and hold
/MUT button
to turn off the unit.
FACEPLATE RELEASE
Press
button to release the removable
faceplate.
SOUND ADJUSTMENT
Press SEL button shortly to select the desired
adjustment mode. The adjustment mode will
change in the following order:
VOL BAS TRB BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
By rotating the volume knob clockwise or
counter-clockwise, it is possible to adjust the
desired sound quality.
SYSTEM SETTING
Press and hold SEL button on the control panel
to enter system setting mode. Then shortly press
SEL button to select the item you want to change
and rotate the volume knob to change the
corresponding setting.
1) BEEP ON/OFF
Use the volume knob to set Beep sound
ON or OFF.
2) AREA EUR/USA
1. Tune/seek/track up button
2.
Release button
3.
/MUTE button
4. Volume knob (when rotated)
SEL button (when pressed)
5. EQ/TA button
6. DISP /Navi-SCH button
7. PTY/AF button
8. MODE button
9. AS/PS button
10.
Tune/seek/track down button
11. Remote sensor
12. USB interface
13. BAND/LOUD/ENT button
14. 1 PAU button
15. 2 SCN
16. 3 RPT
17. 1-6 preset buttons
18. 4 SHF
19. 5 DIR-
20. 6 DIR+
21. Liquid crystal display
22. AUX IN
23. Reset button
24. Memory card interface
Use the volume knob to set AREA
EUR, AREA USA frequency spacing.
Note the frequency range of the different
area is not the same.
3) ) P-VOL
Use the volume knob to select the volume
level when the unit turns on.
DISPLAY INFORMATION
Press DISP button to operate as the conversion
of each display mode.
EQUALIZATION
Shortly press EQ button to turn on equalization
function and to select desired audio mode. There
are five kinds of mode as below:
→FLAT→CLASSICS→POP M→ROCK M →DSP OFF
MUTE
Press
/MUTE button to mute down the sound
instantly. Press again to resume the sound.

Pyle PLR31MP Specifications

General

Brand	Pyle
Model	PLR31MP
Category	Receiver
Language	English