EasyManuals Logo

Pyle PT798SBA User Manual

Pyle PT798SBA
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Additional information
PRECAUTIONS
On
Safety
o Should any solid object or liquid fall into the receiver, unplug the receiver and have it
checked
by
qualified personnel before operating it any further.
On
Power
Sources
o Before operating the system, check that the operating voltage is identical with your local
power
supply.
o The operating voltage is indicated
on
the back
of
the speakers.
o As long as the uuit is not removed from the wall outlet, the uuit will not
be
disconnected
from the AC power source (main) even
if
the uuit itself has been turned off.
o
If
you are not going to use the system for a long time,
be
sure to disconnect the system from
the wall outlet. To disconnect the
AC
power cord, disconnect
by
grasping the plug itself;
never pull the cord.
o
One
contact prong
of
the plug is wider than the other for safety purposes, which will fit into
the wall outlet only one way.
If
you are unable to insert the plug fully into the outlet, contact
your dealer.
o The
AC
power cord should only
be
changed at a qualified service shop.
On
Heat
Buildup
o Although the system heats
up
during operation, this is not a malfunction.
If
you continuously
use this system
at
a large volume, the receiver temperatore
on
top, side and bottom
may
rise
considerably. To avoid burning yourself, do not touch the receiver.
On
Placement
o Place the system
in
a location with adequate ventilation to prevent heat buildup
and
to
prolong the life
of
the system.
o
Do
not
place the system near heat sources or
in
a place subject to direct sunlight, excessive
dust, or mechanical shock.
o
Do
not
place anything on top
of
the receiver that might block the ventilation holes
and
cause malfunctions.
o
Do
not place the system near equipments such as a Tv, VCR, or tape deck.
(If
the system is
being used
in
combination with a TV,
VCR
or tape deck, and is placed too close to such
equipment, noise
may
occur and picture quality
may
suffer. Especially, when using
an
indoor
antenna).
o Use caution when placing the system
or
speakers
on
surfaces that have been specially
treated (with wax, oil, polish, etc.) as staining
or
discoloration
of
the surface
may
result.
On
Operation
o Before connecting other components,
be
sure to turn
off
and unplug the system.
o The center speaker is magnetically shielded to allow it to
be
installed near a
TV
set.
However, color irregularities
may
still be observed
on
certain types
of
TV
sets.
o
As
the front speakers, center speaker and the subwoofer are not magnetically shielded, we
recommend that
you
place them slightly further away from the
TV
set.
o
If
color irregularity is observed, turn
off
the
TV
set then turn it
on
again after
15
to
30
minutes.
. 8 .

Other manuals for Pyle PT798SBA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pyle PT798SBA and is the answer not in the manual?

Pyle PT798SBA Specifications

Output Power IconOutput Power
front output power400W-PEAK x2
center output power400W-PEAK x1
surround output power400W-PEAK x2
subwoofer output power500W-PEAK x1
Drive Unit IconDrive Unit
satellite drive unit3.0 inch
subwoofer drive unit10 inch
Frequency Response IconFrequency Response
satellite frequency response150Hz-20kHz
subwoofer frequency response40Hz-330Hz
Size and Weight IconSize and Weight
subwoofer size420 x 380 x 260mm
L, R channel size140 x 140 x 290mm
surround channel size140 x 140 x 290mm
center channel size400 x 75 x 100mm
net weight38.8 lbs
gross weight43.6 lbs

Related product manuals