BATTERY
INSTALLATION
1.
On
the back
of
the remote control, push the tab and lift
off
the battery cover.
2. Obtain two (2) fully-charged AAA batteries. Match the "+" and
"-"
marks
on
the batteries
to the "+" and
"-"
marks in the battery case, then insert the
new
batteries.
3.~h~~~h=~~~h~~~~~~
should click when the cover is locked.
4. Test the unit
by
pressing
POWER
or
any mode key.
If
the batteries are inserted correctly,
the selected mode key will
blink
once.
Notes
•
Do
not
leave the remote control
in
an extremely
hot
or
humid place.
•
Do
not
use a
new
battery with old ones.
•
Do
not
mix manganese batteries with other kinds
of
batteries.
•
Do
not
expose the remote sensor to direct sunlight
or
lighting apparatuses. Doing so
may
cause a malfunction.
•
If
you do
not
intend to use the remote control for
an
extended period
oftime,
remove
the batteries
to avoid possible damage from battery leakage
and
corrosion.
•
When
you replace the batteries, the remote buttons
may
be
reset to their factory
settings.
If
this happens, reset the buttons again.
Tips
Under normal conditions, the batteries should last for about 3 months. When the remote no
longer operates the receiver, replace all the batteries with
new
ones.
·4
.
To Next Page
Loading...
Need help?
Output Power
