Pylon Technologies RT12100G31 - Page 12

10
Notes:
1.Input signals should be passive signals
2.The voltage value of output signal is less than 25V, and the current value is
less than 10mA.
CAN(COM)
500 Kbps. 120Ω terminal resistance.
RS485/Console(COM)
For manufacturer or professional engineer to debug or service.
Default Communication speed 115200 bps.
Link 1 / Link 0
For battery internal communication between multiple parallel/serial batteries.
Power Terminal +/-
There is a pair of positive and negative terminals with M8 bolts.
BMS basic function
Protection and alarm
Management and monitor
Charge/Discharge End
Cells Balance
Charge Over Voltage
Intelligent Charge Model
Discharge Under Voltage
Capacity Retention Calculate
Charge/Discharge Over Current
Administrator Monitor
High/Low Temperature(cell/BMS)
Operation Record
Short Circuit Protection
Heater Control