Pyronix Enforcer 32-WE Wireless Setup Guide

Enforcer 32-WE Wireless Setup Manual
Page: 10
6. Diagnostics
The diagnostics function shows all wireless input and bell signal strengths and battery status.
6.1 Signal Strength
One of the most important factors for a reliable wireless
installation is the signal strength between a wireless
device and the panel. If a device is out of range it will not
be able to send events to the Enforcer 32-WE panel
therefore it is recommended that a signal strength test is
performed before fixing devices into place.
The Enforcer 32-WE has an advanced signal strength
mechanism that operates by monitoring all inputs/bells
after 5 minutes from the start of the test. It will perform
this test every 16 seconds.
NOTE: When performing a signal strength test it is
recommended that the system is tested in the ‘worst case
scenario’ for example with all doors and windows closed.
Once the function is entered, a count down from 300 will
begin, when 0 is reached the input results display will be
shown, or press  during the countdown to go to the
input display immediately.
One of the following will be displayed:
Result Action
- No device installed
? Waiting for device signal strength information
0 Missing (reposition and retest)
1 Weak signal (reposition and retest)
2 Good install position
3 Excellent signal
The signal strength can also be read from the wireless
device LEDs:
GREEN LED = Good.
RED LED = Bad
When the display is showing the input status, pressing
 will show each individual input and a detailed signal
strength reading will be shown as follows:
Result Action
Excellent [50 to 100] OK to install
Good [30 to 49] OK to install
Weak [0-29] Not OK to install
Missing [-] Not OK to install
Signal Strength Procedure.

Pyronix Enforcer 32-WE Specifications

General

Brand	Pyronix
Model	Enforcer 32-WE
Category	Security System
Language	English