Pyronix Enforcer 32-WE Wireless Setup Guide

Enforcer 32-WE Wireless Setup Manual
Page: 8
4.3 Learning Keyfobs
This sections shows how to learn any keyfobs (KF4-WE) on to Enforcer 32-WE.
Learning keyfobs can only be done from the
master manager menu. Follow the instructions to
the right to enter the Master Manager Menu (for
more information please see RINS1548).
A maximum of 32 keyfobs can be assigned to the
Enforcer 32-WE. Each keyfob has 4 buttons that
can have specific operations:
[0] No action: Disables the button.
[1] Show Status: If the keyfob is learnt, the LED
will flicker when the nominated button is pressed.
GREEN = Unset. RED = Set.
[2] Set Area: Sets the chosen area.
[3] Unset Any Area: Unsets any area on the
system.
[4] Latch Output: Latches an output
(programmable) when the nominated button is
pressed.
[5] Timed Output: Activates an output for a
period of time (programmable in seconds).
When learning a keyfob, any button must be held
until the LED flashes GREEN and RED, and then
when released, a GREEN LED will be shown,
asterisks will appear in the brackets on the keypad
and an acknowledgement beep will be heard, all
indicating a successful learn.
Keyfob buttons can also be programmed in the
engineer menu, in the same way as shown here
(please see the programming manual for more
information).
Deleting Keyfobs
To delete a keyfob, press  when the display
shows ‘Delete User' in the 'CHANGE CODES' menu.
Learning Procedure.
KF4-WE
Press and hold any button on
the keyfob until the RED and
GREEN LEDs flash, then
release.
Press 
Enter Master Manager Code
Press 
In
D
ay Mode
Enforcer 32-WE
Time 8:30am c
Enter Your Code
[******]
Press 
SET DATE & TIME?
CHANGE CODES?
Press 
Add New User?
Press 
Enter name, Press 
Use [ or ]. Press 
Use [ or ]. Press 
Empty [02]
Enter user code
[ ]
User Name
_
Select Button
Lock [1]
Button Action[2]
Set Area

Pyronix Enforcer 32-WE Specifications

General

Brand	Pyronix
Model	Enforcer 32-WE
Category	Security System
Language	English