Pyronix Enforcer 32-WE Programming Reference Manual

Page: 31
keypad sounders and then depending on where it’s programmed to stop at -will progress up to a
maximum of communicating the alarm event i.e. ‘Digi’. Each alarm response will take 15 seconds
before moving on to the next.
5.16.2 Area A, B, C, D Stops at:
Alarms for each area can stop at: Keypads, Internal Sounders, Bells Only and Signal Digi. For
example, if programmed to start at keypad and stop at keypad this means the alarm will only be
ever displayed on the keypad.
5.16.3 Fire Alarm Starts at:
This feature programs the starting point of alarm responses for fire alarm. The levels are: Keypads,
Internal Sounders, Bells Only and Signal Digi.
5.16.4 Fire Alarm Stops at:
This feature programs the ending point of alarm responses for fire alarm: Keypads, Internal
Sounders, Bells Only and Signal Digi.
5.16.5 Gas Alarm Starts at:
This feature programs the starting point of alarm responses for Gas alarm. The levels are:
Keypads, Internal Sounders, Bells Only and Signal Digi.
5.16.6 Gas Alarm Stops at:
This feature programs the ending point of alarm responses for Gas alarm: Keypads, Internal
Sounders, Bells Only and Signal Digi.
5.16.7 PA Alarm Starts at:
This feature programs the starting point of alarm responses for PA alarm. The levels are: Keypads,
Internal Sounders, Bells Only and Signal Digi.
5.16.8 PA Alarm Stops at:
This feature programs the ending point of alarm responses for PA alarm: Keypads, Internal
Sounders, Bells Only and Signal Digi.
5.16.9 24 Hour Alarm Starts at:
This feature programs the starting point of alarm responses for 24h alarm. The levels are:
Keypads, Internal Sounders, Bells Only and Signal Digi.
5.16.10 24 Hour Alarm Stops at:
This feature programs the ending point of alarm responses for 24h alarm: Keypads, Internal
Sounders, Bells Only and Signal Digi.
5.16.11 Any Alarm Starts at:
This feature overrides the settings above. It can be used to create greater flexibility in the use of
the alarm responses feature and in this case it’s set up for each area if they are in armed status
only.
5.16.12 If Areas Armed
Select the areas that the following settings will be applicable to.
5.16.13 Any Alarm Stops at:
For example, if 24 Hour Alarm is set to Start at Keypad and stops at Keypad, this feature allows set
up for all Areas if they are armed to make any alarm stopping at Digi.
5.16.14 If Areas Armed
Select the areas that the above setting will be applicable to.

Pyronix Enforcer 32-WE Specifications

General

Brand	Pyronix
Model	Enforcer 32-WE
Category	Security System
Language	English