Matrix User Guide
RINS915-2 Page: 17
First To Alarm (FTA) Mode
The bell icon (z) flashes slowly indicating that you are in FTA mode.
This mode allows you to view the first zone that went into, and thus caused, the alarm. This will always be for
the last partition you selected. If the keypad enters hidden display mode whilst in FTA mode, simply re-enter
your code to re-display the FTA information.
To disarm the partition(s), enter your personal user code TUV
and select the partition(s) you want to
disarm, followed by the key to confirm.
The selected partitions will disarm.
In Alarm (Zone 1) Choose FTA FTA (Zone 1) Disarmed
(( ))
4.1.9 Latched Alarm Condition – Denmark, Finland, Norway & Sweden Only – Multiple
Partition
A special indication will appear on the ICON display after any valid alarm has been successfully disarmed. The
ICON keypad will flash the bell icon (z) at twice the normal rate. Whilst this display is active, the keypad will not
enter hidden display mode (if hidden display mode is enabled).
This is to prompt you to check the event log. To stop the bell icon (z) flashing you must use the user function
View Log described on page 27. Alternatively, enter a valid user code to re-arm the panel. Once armed, the
previous latched alarm will be cleared.
4.1.10 Anti-Code Reset – Multiple Partition User
If your system has anti code reset enabled, the two segments of the corner partition segment for the partition in
question will flash alternately. The partition icon will also flash, indicating that the partition is in anti-code reset.
You will be unable to re-arm your alarm panel until an anti-code number has been entered. Press the C key to
display the anti code seed number. The number is displayed one digit at a time. This number should be passed
onto your central monitoring station, who will in turn provide you with a corresponding anti code number.
Enter this anti code number on your keypad (after pressing the C key).
Your system will return to normal operation.
If the keypad drops into hidden display mode, re-enter your user code to unhide the display and press the C
key to re-display the anti-code seed number.
To Next Page
Loading...
Need help?
General
