To Next Page

To Previous Page

still enabled).

You can still remote start the vehicle after the turbo timer has timed out

and shut off the vehicle. For safety reasons, if a door is opened or if the

ALARMISTRIGGEREDWHILEYOUAREAWAYTHEREMOTESTARTEXITSTHEMANUAL

transmission mode and does not remote start until the MTS sequence

is re-initiated.

Note: An optional push button can be hard wired to the (-) activation

INPUT(ONTHEREMOTESTART4HISALLOWSTHEUSERTOACTIVATETHE

turbo timer without having to use the remote.

When the vehicle is running follow the procedures listed above, but

instead of pressing the remote, press the push button the appropriate

number of times to activate the remote start (factory setting is for 1

pulse). The remote emits the remote start conﬁrmation tone, after which

YOUCANTURNOFFTHEIGNITIONANDEXITTHEVEHICLE4HECARREMAINSRUN-

ning for the pre-programmed amount of time.

Runtime check

Command

: While the remote start is running, press two-times,

and then Hold for 1.5 seconds.

Feedback

: 4EXTREADSRUNTIMEANDDISPLAYSTIMELEFT

Notes

: This feature is only available on the 2way remote.

Runtime reset

Command

: While the remote start is running, press one-time and

then

Feedback

: Remote start ON tones.

Notes

: Re-starts the remote start runtime counter if remote start

is active. Note: If remote start is not active, the 2-WAY

Python 991 User Manual

Questions and Answers: