To Next Page

To Previous Page

remote will respond with error tone.

Rear defogger

Command

: Press four times, and then . (Only after remote

start is on.)

Feedback

: $EFOGGERICONAPPEARSONREMOTEANDTEXTREADS$EFROST

On.

Notes

: While the remote start is running the defroster will manu-

ally be turned on for one remote start cycle. When the

remote start shuts down, the defroster will work normally.

The defroster turns on when the temperature inside the

vehicle is 55 degrees or below when this feature is

wired and enabled.

Smart start

Command

: Press three-times and then press .

Feedback

: 4HEVEHICLESPARKINGLIGHTmASHTIMESFASTANDTHETEXT

on the 2way remote reads Smart Start On

Notes

: Enables or disables the SmartStart feature. The smart

start feature of this system will allow you to have the

remote start activate when the vehicle reaches a certain

temperature (hot or cold) or a certain voltage. The fac-

tory setting for temperature high is 100 °F the setting for

low is 0 °&4HEVOLTAGESETTINGISFOR6

These settings can be adjusted or turned off by your

installer when using the Bitwriter.

To activate the Smart Start Mode with a manual transmission:

Enter the MTS procedure.1.

%XITTHEVEHICLEANDPRESSTHE2.

button on the remote (the vehicle

Python 991 User Manual

Questions and Answers: