60 61
PICTURE 4-25
PICTURE 4-26
4.5 REMOTE DEVICE
While cameras connected directly to the NVR through the POE ports will automatically
connect and display video, remote cameras connected to your system must be located
and added manually. This can be done through the process described in Section 2.4 IP
Cameras at the beginning of this manual or through the Remote Device window.
Use of remote devices requires that your NVR is connected to a router. These devices can
be IP cameras or even QC-series DVRs. If you intend to connect to devices that are located
outside of your local network, then this router must be able to access the Internet. Instructions
for connecting your system to the Internet are presented in the Remote Monitoring Guide
that also came on the CD with your system. It is also available from our online resource at
www.Q-See.com/Support.
Similarly, the remote devices must be able to communicate with the local network or Internet.
This will be covered in Chapter 4 of the Remote Monitoring Guide as well.
This window can be reached by clicking on
the Remote Device icon in the Main menu...
MAIN MENU
SEARCH
INFO
ADVANCED BACKUPREMOTE DEVICE
SHUTDOWN
SETTING
RECORD SETTINGS
...or through the Shortcut menu by right-
clicking on the screen and selecting Remote
Device.
PICTURE 4-27
REMOTE DEVICE
Show Filter
None
Delete Manual Add
IP Search Add
OK Cancel
4 IP Address Port Device ID Manufacturer Type
1 10.1.1.65 Port 1 YZC2OC061966 Private IPC
2 10.1.1.67 Port 2 YZCAU192012 Private IPC
3 10.1.1.68 Port 4 TC2FW25600095 Private IPC
4 196.219.8.50 4000 Private
channel Edit Delete IPC Config Status IP Address Port Device ID
1 196.610.6.46 37777
2 10.1.1.67 Port 2 YZCAU192012
3 10.1.1.68 Port 4 TC2FW25600095
4 10.1.1.65 Port 1 YZC2OC061966
Device Added
When the window opens, you will be presented with a list of all connected devices in the
lower portion. This section, marked Device Added, indicates the status of each device along
with other information about it.
Icon Meaning Description
Editable
You may edit the settings on this device by double-clicking on it
Cannot
Delete
This device is connected directly to the NVR and must be physically
unplugged to be removed from this list.
Removable
This device may be deleted from the list by checking the box next
to it and clicking on the Delete button below.
Configure
IP Camera
Clicking on this icon will allow you to configure the video from this
camera.
Device
Status OK
The connected device is operating normally.
Device
Error
There is an issue with the connected device that is preventing it
from operating normally.
Clicking on IP Search under the upper portion of the window will generate a list of all devices
that the NVR was able to locate - both directly connected as well as connected to the same
network as your system. Items showing a short IP address beginning with “10” are cameras
directly connected to the NVR and who’s IP addresses were assigned by the NVR itself. Care
should be taken that you do not attempt to connect a device that is already connected to the
system as it will create a duplicate video feed and could cause connectivity issues.
To Next Page
Loading...
Need help?
General
