Manual for Advance 6T series
GREEN LED Connector (GREEN LED)
When the system is in S0 status, ACPI S1,S4 or S5 status, the LED is off. When the system
is in APM suspend status, the LED is on.
Hardware Green Connector (SLEEP)
Push once the switch connected to this header, the system enters suspend mode.
HD_LED
SPEAKER
ACPI LED
RESET
POWER
SW
SLEEP
GREEN LED
KEYLK
PWR_LED
SPEAKER
RESET
GREEN LED
KEYLK
ACPI LED
SLEEP PWR_ LED
HDD LED(+)
HDD LED(-)
ORANGE(-)
GREEN(-)
LED+
POWER
GND
EMPTY
EMPTY
SLEEP
GND
LED+
LED-
LED- KEYLOCK
GND
LED-
LED-
LED+
EMPTY
GND
RESET
SPKDATA
NC
GND
VCC
POWER
SW
Chapter 2
Audio/Modem Riser Slot( AMR )
The AMR Interface Connector is the interface between the mainboard and the Audio/
Modem Riser card. The connector provides all necessary signals which supports several
different configurations of audio and modem in the system, such as audio and modem on
the riser, audio on the mainboard and modem on the riser, or no audio with modem on the
riser. Either AMR (Audio/Modem Riser) card or MR (Modem Riser) card can be used on this
system. To avoid conflict, the onboard audio can be disabled by jumper JSD when using
codec on AMR card.
IrDA
1
AMR Slot
To Next Page
Loading...
