– 6 –
IF ANY PARTS ARE
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.
STARTING AND STOPPING
1. Connect the unit to a power supply of the
correct voltage and frequency (120V-60HZ).
2. To start the saw press the switch to the
“I” position (Fig 4).
3. To stop the saw, press the switch to the “O”
position (Fig 4)
FOR YOUR OWN
SAFETY, ALWAYS POSITION THE SWITCH
TO THE “O” POSITION WHEN THE SAW IS
NOT IN USE. IN THE EVENT OF A POWER
FAILURE, BLOWN FUSE OR TRIPPED CIRCUIT
BREAkER, PRESS SWITCH TO THE “O”
POSITION. THIS WILL PREVENT THE TOOL
FROM STARTING UP AGAIN WHEN THE
POWER COMES BACk ON.
FIGURE 4
1. Clean the working area.
2. Remove saw from carton, you will find
it assembled.
3. Lay the saw on its side on the ground (Fig 5).
FIGURE 5
4. Pull out the stand legs, and the support
brackets (Fig 5-1). Attach the brackets to the
legs with the key hole and support pin
located on each leg (Fig 5-2).
FIGURE 5-1
FIGURE 5-2
5. Stand the saw upright.
6. Adjust the balance screw on right leg (Fig 6).
FIGURE 6
7. To mount the handle position the handle on
the trolley and secure it using the 2 screws
(Fig 7).
To Next Page
Loading...
Need help?
General
